How to take off nintendo switch controller case?

How to Remove the Nintendo Switch Controller Case: A Simple Guide

The Nintendo Switch controller comes with a sleek and sturdy case designed to protect it from damage. However, on occasion, you might need to detach the case to clean or modify the controller or to replace a worn-out palm grip. In this article, we will break down the step-by-step process for Removing the Nintendo Switch Controller Case.

Understand the Case Construction

Before dismantling the case, it’s essential to gain an understanding of its design. The cases are made of plastic and have clip-like mechanisms to attach to and detach from the controller.

Equipment Needed

  • The Nintendo Switch Game Controller

  • A Phillips screwdriver (£1-£5 pounds)

  • A Plastic Spoon or similar flathead tool (£less than £1 pound)

    • Tip: You must have a Phillips screwdriver to work with the controller.

Guide to Removing the Case

Securing the Controller

  1. Choose a flat surface, and stand the controller upright to prevent shifting during the process.

  2. Make certain the controller is properly aligned prior to proceeding to the next instructions.

Locating the Joints

<h3locate the joints

1 Locate the joints or clips joining the case to the controller:
‣ You will find these clip-and-groove connection points on the top surface of controller, near the Joy-Con or the analog stick.
2 Keep in mind, as you proceed into the next steps, there might be slight dissimilarities in terms of configuration, depending on whether you plan to remove the palm grip pad or the entire casing.

1st Step: Lift the Case

  1. Slowly prying the case using a fork or a similar utensil
    ‣ Start off by gently grasping from the top edge     of

    the case h3> and pushing it ever so slightly downward. By doing this, you increase the gap between the joint and the controllers.
    2 Make sure these joints are pried from the controller but not off. Once you managed to create space, put the fork or other tool aside – you will not use it again.

In the following steps, take care no to force the case; you also do not want to lose the clips if they break.

Step 8: Remove the Case Completely

There are two ways of removing complete case:

  1. Method One: Remove the Palm Grip Pad without the Case
    If you opt for this method:
    *Remove the palm grip pad directly from the controller without re-removing the case yet.
    2 Method 9: Remove the Case by Pull-off
    If you choose the removal of cover, you will pull it with your hands.
    ‍♂️Take hold

Removing Palm Grip, Case, and Screen Protector Optional

Removing or Replacing a WORN-OUT Palm Grip 3

1 There are two ways you can customize your controller: with a thumb grip or a normal grip.
Please note that before proceeding below, you must follow the instructions presented in the previous article.
2 Here are the steps in case.
‣ Remove

Removing Palm Grip

Additional Tips**

  • Remove the case but do not forcefully remove

  • Do not use force against the controller – you might void the warranty.

  • After removing screen protector, clean up the controllers with a soft cloth before applying clean screen protector for protection while playing.

Final Thoughts of Removing the Nintendo Switch Controller Case

• Removing Nintendo Switch controller the case is a task that appears to be very complicated, but it is actually rather simple If you follow the steps you will save yourself from wars and frustration with the hardware.
• Remember, it's essential; you must detach the case the right way to repair or modify your games controller.

FAQs ABOUT REMOVING NINTENDO SWITCH CONTROLLER CASE ARE HERE

When I Should Remove the Case

  • to clean the controller’s exterior case

  • to attach a new hand grip

  • in case needed to replace a faulty or damaged element

Leave a Comment